Hanna-instruments HI 83266 Instrukcja Użytkownika Pobierz pdf (Strona 8)

14 15

METHOD REFERENCE TABLE

Method Method Page

description

1 Alkalinity 20

2 Bromine 22

3 Calcium Hardness 24

4 Free Chlorine 27

5 Total Chlorine 29

6 Free Copper 31

HEALTH & SAFETY

• The chemicals contained in the reagent kits may be hazardous if improperly handled.

• Read the Material Safety Data Sheet (MSDS) before performing tests.

• Safety equipment: Wear suitable eye protection and clothing when required, and follow instructions

carefully.

• Reagent spills: If a reagent spill occurs, wipe up immediately and rinse with plenty of water.

If reagent contacts skin, rinse the affected area thoroughly with water. Avoid breathing released vapors.

• Waste disposal: for proper disposal of reagent kits and reacted samples, refer to the Material Safety

Data Sheet (MSDS).

Method Method Page

description

7 Total Copper 33

8 Cyanuric Acid 35

9 Iron 37

10 Ozone 39

11 pH 42

specific method.

• It is possible to take multiple readings in a row, but it is recommended to take a new zero reading for

each sample and to use the same cuvette for zeroing and measurement when possible (for most precise

results follow the measurement procedures carefully).

• Discard the sample immediately after the reading is taken, or the glass might become permanently

stained.

• All the reaction times reported in this manual are at 25 °C (77 °F). In general, the reaction time

should be increased for temperatures lower than 20 °C (68 °F), and decreased for temperatures higher

than 25 °C (77 °F).

INTERFERENCES

• In the method measurement section the most common interferences that may be present in an average

sample matrix have been reported. It may be that for a particular treatment process other compounds

do interfere with the method of analysis.

POWER CONNECTION AND BATTERY MANAGEMENT

The meter can be powered from an AC/DC adapter (included) or from the built-in rechargeable battery.

Note: Always turn the meter off before unplugging it to ensure no data is lost.

When the meter switches ON, it verifies if the power supply adapter is connected. The battery icon on the

LCD will indicate the battery status:

- battery is charging from external adapter - battery fully charged (meter connected to AC/DC adapter)

- battery capacity (no external adapter) - battery Low (no external adapter)

- battery Dead (no external adapter)

OPERATIONAL GUIDE

• Turn the instrument ON via the ON/OFF power switch.

• The meter will perform an autodiagnostic test. During this test, the Hanna Instrument logo will appear

on the LCD. After 5 seconds, if the test was successful, the last method used will appear on the display.

• In order to select the desired method press the METHOD key and a screen with the available methods

will appear.

• Press the s t keys to highlight the desired method. Press Select.

METHOD SELECTION

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 24 25

Komentarze do niniejszej Instrukcji

Brak uwag

Hanna-instruments HI 83266 Instrukcja Użytkownika Strona 8

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Urządzenia pomiarowe Hanna-instruments HI 83266