Hanna-instruments HI 23 Instrukcja Użytkownika Pobierz pdf (Strona 9)

1716

SETUP CODES

The following table lists the setup codes along with the descrip-

tion of the specific setup items, their valid values and whether

password is required to view that item (“PW” column):

Code Valid Values Default PW

00 Factory ID 0 to 9999 0000 no

01 Process ID 0 to 99 00 no

02 Control enable/disable 0: C.M. disabled 0 no

1: C.M. enabled

03 Range 1: 0.0-199.9 µS (or 100.0 ppm) 4 no

(depends on model) 2: 0-1999 µS (or 1000 ppm)

3: 0.00-19.99 mS (or 10.00 ppt)

4: 0.0-199.9 mS (or 100.0 ppt)

04 Reference Temperature 20°C or 25°C 25°C no

05 Temperature Coefficient 0.00 to 10.00 %/°C 2.00 no

06 Input Selection 0: conductivity probe 0 no

1: 4-20 mA input signal

07 Temperature ATC: Automatic ATC no

compensation User: Manual

08 TDS Factor 0.00 to 1.00 0.50 no

11 Relay 1 mode 0: disabled 0 no

(M1) 1: ON-OFF high setpoint

2: ON-OFF low setpoint

3: PID, high setpoint

4: PID, low setpoint

12 Relay 1 setpoint (S1) 0.5 to 99.5% full scale 25% f.s. no

13 Relay 1 hysteresis (H1) 0 to 5% f.s. 1% f.s. no

14 Relay 1 deviation (D1) 0.5 to 10% f.s. 1% f.s. no

15 Relay 1 reset time 0.1 to 999.9 minutes 999.9 no

16 Relay 1 rate time 0.0 to 999.9 minutes 0.0 no

Note The default password is set at “0000”.

• The LCD will display “SET” on the up-

per part and “c.00” on the lower, al-

lowing the user to edit setup param-

eters (see table below).

• Using the arrow keys as for the above password proce-

dure, enter the code of the parameter to set, e.g. 41.

• Confirm the code by pressing CFM and the default or the

previously memorized value will be displayed with the

first digit blinking.

Note When the password is not inserted or a wrong password is

confirmed, the display will only show the previously memo-

rized value, without blinking (read only mode). In this case,

the value cannot be set. Press LCD and start again.

• Enter the desired value using the arrow keys and then press

CFM.

• After confirmation, the selected parameter is

displayed. The user can scroll through the

parameters by pressing CFM.

• In order to directly set another param-

eter, press SETUP again and enter the

code or scroll to it by pressing CFM.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 30 31

Komentarze do niniejszej Instrukcji

Brak uwag

Hanna-instruments HI 23 Instrukcja Użytkownika Strona 9

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Urządzenia pomiarowe Hanna-instruments HI 23