Hanna-instruments HI 504 Instrukcja Użytkownika Pobierz pdf (Strona 31)

6160

Following is the complete list of commands available:

Command Parameter Remarks

NNMDR not available Requests firmware code

(always available)

NNHOP not available Requests hardware options

NNSNR not available Requests hardware identifier

(always available)

STS not available Requests instrument status

(relays, LEDs, configuration

change flag, etc.)

PHR not available Requests last pH reading

(instrument configured for pH)

NNMVR not available Requests last mV reading

(always available)

TMR not available Requests temperature reading

(instrument configured for pH)

CAR not available Requests all last calibration data

(always available)

NNGET CNN Requests setup item C.NN.

Use the NNSNR command if

hardware identifier is needed.

(NNGET command is

answered with

“<ProcessID><CAN>”

for the hardware identifier)

NNPWD C

Sends the general password

(always available)

NNSET CNNP

Sets setup item C.NN with

parameter P

(*)

(not available in setup mode)

NNEVF not available Requests event log file

(available in idle, event

scrolling or last calibration data

scrolling mode w/control OFF)

Line conditions, pull-up and pull-down resis-

tors should be connected as shown.

The Fail-Safe resistors are connected only to

one unit in the line, and their value depends

on the application and characteristic imped-

ance of the connection cable.

The GND pin of the interface connector and all the interface

signals are optoisolated from the ground of the instrument,

the electrode and the temperature sensor.

Before connecting the meter to the computer, consult the com-

puter manual.

The process controller can only work as a slave component.

In other words it can work as a remote terminal equipment

answering to the commands only.

RS485 PROTOCOL FOR HI 504

Commands are composed of four parts: addresses, com-

mand identifier, parameter, end of command.

Some commands are used when the master is requesting

information from the controller, other when the master wants

to set a parameter in the process memory (RAM or EEPROM).

The end of commands corresponds to the CR char (0x0d).

The master software must send the command string with a

maximum delay of 20ms between each character.

The program on the master must not allow setting commands

other than keyboard or cleaning start/stop commands if the

general password has not been entered. After the general

password recognition through the “PWD” command, a 1-

minute time-out is let before the process meter locks again,

i.e. if the PC program waits for more than 1 minute between

two subsequent setting commands, the second one is not

fulfilled and the “PWD” command must be issued again.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 58 59

Komentarze do niniejszej Instrukcji

Brak uwag

Hanna-instruments HI 504 Instrukcja Użytkownika Strona 31

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Urządzenia pomiarowe Hanna-instruments HI 504